How to set the wire stripper
Source:     Author: rsautomation88    Publish time: 2022-05-17 14:29    600 Views
Wire stripping machine is the withdrawal of modern science and technology progress, to solve the traditional manual processing wire pain, not only has the very big promotion in the working efficiency, compared with the traditional processing after the success of the peel by wire stripping machine with higher precision, and there are a lot of people still don't know how to set the wire stripping wire stripping machine this problem, here is to find out together!
1. Preparation before stripping
1. Check whether the parts of the machine are loose.
2, turn on the power, check whether the power indicator is normal, whether the machine leakage.
3, test run the machine, check whether the machine is running normally, there is no abnormal sound.
4, confirm whether the processed wire is consistent with the specified in the operation guide.
Two, stripping machine operation rules
1. When setting wire stripping parameters, the total length must be greater than the front-end length + back-end length; Otherwise the machine may be out of control when working;
2, when using the communication control this machine, must ensure that the machine is displayed in the working screen and non-parameter setting state, otherwise the communication control is invalid;
3. Run at an appropriate speed;
4, in the working screen and non-parameter setting, can directly press, [W] key to set the knife value; Press ↑ and ↓ to set the knife value; Press [←] or [→] key to set the tool back without stopping;
5. If the four running indicators blink, it indicates that the set parameters at this time cannot start the machine;
6, twist setting: the front twist offset parameter is specially set for the function of short twist, meaning when the machine is finished stripping the front end, the distance from the wire to the back twist wheel; Sometimes the short line can install the blade to the torsion wheel, then can set this parameter small, you can reach the short line torsion function;
Three, matters needing attention
1. The wire stripper must be operated by trained personnel, who should be familiar with the general performance and structure of the machine, and master the prevention, judgment and emergency handling measures of equipment failure.
2. When leaving the machine in the production process, the machine should be suspended and people should stop when leaving the machine.
3. Fingers shall not be near the knife holder and chuck during the operation of the machine to prevent clamp injury.
4, failure should be immediately shut down, circuit short circuit, smoke, leakage should be cut off the power supply, after troubleshooting can be started, equipment can not take fault overload operation.
The above is about the stripping machine set stripping questions, I hope to help you.

上一篇： Automatic ......
下一篇： High speed......
Technical Support
Product
Home